Use this radar Y cable to split the radar signal to more monitors. It has a short lead to split an existing radar lead and then a 10' lead to reach a new monitor. All connectors are the 4 pin Amp connectors which are compatible to all planter monitors. This also is the "Y" cable to use to split behind most Case/IH Magnum tractor dashes (except the MX series).

AE2564 - Genesis Tractor radar Y Cable

If you have a Ford Genesis Tractor, use this radar Y cable to split the signal for planter monitors, sprayer controls and others. It has two gray colored connectors to split the lead at the radar and a 10' lead with an Amp connector to bring the cable into the cab. TW tractors would use the AE2554 "Y" cable above and split behind the dash.

AE3259 - Dickey-john Radar Y to Raven Cable

This cable is used where a planter monitor already exists and you are wanting to add a connection to for a Raven controller or Capture unit. Check lengths on picture.

AE2556 - John Deere Magnavox

This "Y" cable is built for the 55 & 60 series John Deere tractor using the Magnavox or Phillips Radar gun. It uses the 4 pin square Weather Pak connectors at the radar Y and a 4 pin Amp connector for planter monitors, etc. (WARNING! This cable is NOT to be used with the CASE IH Radar!)